Click Basic Setup, then select Enabled in the DHCP Server Setting section. However, if the secondary router's DHCP is not enabled, make sure to enable it by visiting the web-based setup page. This will set the secondary router to a different IP segment from the primary router.įor example: Main router: 192.168.1.1 => Secondary router must be: 192.168.2.1īy default, the DHCP feature of Linksys routers is enabled. Make sure that the Subnet Mask is 255.255.255.0. If the IP address is the same as the primary router, change the number in the third box to a different value. Step 4: In the Basic Setup tab, find IP Address or Local IP Address.įind the IP Address or Local IP Address in the Basic Setup tab Step 3: Go to the settings page of the secondary router. Connect the Linksys router to another router (LAN-WAN) However, Guest Access is still allowed if the connection is LAN to WAN. In cascading routers, specifically LAN-LAN connection, setting the slave router to Bridge mode will not allow visitors to access. Note: A single router placed in Bridge mode disables the router's Guest Access feature. Quick tip: If you have a wireless router, you can proceed to configure its WiFi settings. Step 8: Reboot the secondary router and after the power light is on, check if you can access the internet on your device. Make sure that the primary router is still connected to the modem through the Internet gateway. Step 7: Unplug the cable from the computer and connect it to one of the Ethernet ports on the main router. Step 5: For DHCP Server Setting, set DHCP Server to Disabled. Note: If the IP address is the same as the primary router, change the number in the fourth box to a different value.įor example: Main router: 192.168.1.1 => Secondary router must be: 192.168.1.2 Step 4: In the Basic Setup sub-tab, look for IP Address or Local IP Address. Step 3: Go to the web-based setup page of the secondary router. Step 2: Connect your computer to one of the Ethernet ports of the secondary router. Step 1: Check and write down the IP address of the primary router. There are two ways to connect the Linksys router to another router: Connect the Linksys router to another router (LAN-LAN) Contact your Internet service provider (ISP) if you cannot connect to the Internet directly from your modem. The primary router must have an active Internet connection before connecting to the secondary router. If you want to pair a non-Linksys router with a primary router, you need to contact the manufacturer for assistance. The second router must be from Linksys and called the secondary router. In this case, the first router could be Linksys or another provider and is called the primary router. Connect more devices (wired and wireless).
Improve network performance without removing old router.Cascading is a term used when connecting one router to another.